Author Topic: RC1: Search-Replace <Current Procedure> scope, error  (Read 942 times)

JimmieC

  • Senior Community Member
  • Posts: 423
  • Hero Points: 15
RC1: Search-Replace <Current Procedure> scope, error
« on: October 21, 2015, 05:29:43 pm »
I was performing a Search-Replace with <Current Procedure> scope and got an error. I was using the GUI and incrementally approving each replacement.

Attached is a screen shot and a text file with the Slick-C Stack.

However, I must say, that RC1 overall is a really nice piece of work.

Jim

JimmieC

  • Senior Community Member
  • Posts: 423
  • Hero Points: 15
Re: RC1: Search-Replace <Current Procedure> scope, error
« Reply #1 on: October 21, 2015, 05:44:24 pm »
It happened again. But, this time noticed an extra clue.

When I switch back to the Find In Files tab, the tab changes focus correctly but the pane stays at the Replace pane.

See attached image.

Jim

Dan

  • SlickEdit Team Member
  • Senior Community Member
  • *
  • Posts: 2290
  • Hero Points: 128
Re: RC1: Search-Replace <Current Procedure> scope, error
« Reply #2 on: October 21, 2015, 05:46:23 pm »
Reproduced.  We'll look into this.
« Last Edit: October 21, 2015, 05:48:13 pm by Dan »

Dan

  • SlickEdit Team Member
  • Senior Community Member
  • *
  • Posts: 2290
  • Hero Points: 128
Re: RC1: Search-Replace <Current Procedure> scope, error
« Reply #3 on: October 21, 2015, 06:39:11 pm »
This is actually an old bug, but in previous versions it gave a quiet "Invalid selection" message on the message line, and now it gives a Slick-C stack.  We're looking into it.

Dan

  • SlickEdit Team Member
  • Senior Community Member
  • *
  • Posts: 2290
  • Hero Points: 128
Re: RC1: Search-Replace <Current Procedure> scope, error
« Reply #4 on: October 22, 2015, 02:28:25 pm »
This is fixed for the next drop.