« previous next »
Pages: [1]   Go Down

Author Topic: Selective display didn't catch all block ?  (Read 2032 times)

jmfrouin

  • Senior Community Member
  • Posts: 103
  • Hero Points: 2
Selective display didn't catch all block ?
« on: October 03, 2018, 03:52:23 PM »
Hi
I activate selective display, but I have some insctructions not catch, in screenshot, if at line 341 isn't catch, but the one at line 357 is :(
Is it normal ?
Thanks
Logged

Dennis

  • Senior Community Member
  • Posts: 3965
  • Hero Points: 517
Re: Selective display didn't catch all block ?
« Reply #1 on: October 03, 2018, 05:56:17 PM »
How did you active select display (there are many options).
Logged

jmfrouin

  • Senior Community Member
  • Posts: 103
  • Hero Points: 2
Re: Selective display didn't catch all block ?
« Reply #2 on: October 03, 2018, 07:52:04 PM »
I enable it by menu : Menu -> View -> Selective Display
Multi level outline, Braces and remember sub levels set
Logged

b

  • Senior Community Member
  • Posts: 325
  • Hero Points: 26
Re: Selective display didn't catch all block ?
« Reply #3 on: October 03, 2018, 08:04:15 PM »
Tools> Options> Appearance> General> Selective Display Bracketing> On
(Left the other default parameters).

But then I had to go to Menu> View> Selective Display (as image shown) to get it to "take" (and then it appears to take only for the current file).
Logged

jmfrouin

  • Senior Community Member
  • Posts: 103
  • Hero Points: 2
Re: Selective display didn't catch all block ?
« Reply #4 on: October 03, 2018, 08:10:58 PM »
Yes agree with b :) again
Logged

Dennis

  • Senior Community Member
  • Posts: 3965
  • Hero Points: 517
Re: Selective display didn't catch all block ?
« Reply #5 on: October 04, 2018, 02:05:41 PM »
Yes, that's just a limitation at the moment.
Logged
Pages: [1]   Go Up
« previous next »