Author Topic: v25 Beta2: back button leaves me on LINE ONE of the target file  (Read 806 times)

SkateLegged

  • New Community Member
  • Posts: 1
  • Hero Points: 0
v25 Beta2: back button leaves me on LINE ONE of the target file
« on: September 21, 2020, 05:02:59 PM »
v25 Beta2:

Problem: The Navigate-Back button leaves me at line 1 of the target file.
Ideally I'd rather be returned to the exact line number I was on the last time I was in that target file.

Note that this problem is seen only upon FIRST TIME open and LOOKUP of a #define. Subsequent lookups,
after having had the file open a while, start to work fine, and then the back button returns me to the
correct line number. So it's a first-time init problem, not a permanent all-the-time problem!

No response expected here. I'm just reporting what I see in v25 Beta2.  Thanks!