Author Topic: Crash with workspace and Sourcecontrol  (Read 166 times)

FM.WK

  • New Community Member
  • Posts: 2
  • Hero Points: 0
Crash with workspace and Sourcecontrol
« on: March 24, 2021, 03:10:46 pm »
Hi,

we upgraded to Slickedit 25.0.1 32bit. In the past years we used diffrent other slickedit version. With the new version we had a problem in combination with workspaces and a source control. We used as source control provider "SourceGear Vault Standard Classic Client". I can configure a workspace and initialize the source control provider. Then some dialogs was shown and I can work with the source control. If I close the slickedit and open it again, the source control login dialog will shown but slickedit crash in loading/opening the workspace. I only can work with the slick edit again after I edit the vpj workspace file and remove the source control informations.
As early mention in the early slick version this worked fine.

Any suggestion for a solution?

Greets Florian

Dan

  • SlickEdit Team Member
  • Senior Community Member
  • *
  • Posts: 2545
  • Hero Points: 141
Re: Crash with workspace and Sourcecontrol
« Reply #1 on: March 24, 2021, 03:15:12 pm »
This is SCC, correct?  Nothing about the version control system has changed, correct?

What version of SlickEdit did you upgrade from?

FM.WK

  • New Community Member
  • Posts: 2
  • Hero Points: 0
Re: Crash with workspace and Sourcecontrol
« Reply #2 on: March 24, 2021, 03:39:12 pm »
Yes SCC. The Sourcegear Vault Version Control system has the same version as with the older slick edit version.
We used before the version 24.0.2.

Dan

  • SlickEdit Team Member
  • Senior Community Member
  • *
  • Posts: 2545
  • Hero Points: 141
Re: Crash with workspace and Sourcecontrol
« Reply #3 on: March 24, 2021, 03:41:48 pm »
 Can you PM me your email address so I can send you a DLL with some debug in it?