SlickEdit Product Discussion > SlickEdit®

Making the Build window just another tab

<< < (3/3)

LBCEi:
Thanks for the suggestions.

Renaming vrestore.slk or vslick.sta didn't help.  Neither did making minor changes to the menu.

However, what did work was the following:

* Delete the Send Output to Editor Window item from the menu
* Close the .process buffer editor tab
* Issue the toggle-process-tab-output command at the command line -- Process already running message resulted in the status bar
* Issue the toggle-process-tab-output command at the command line again -- no message in status bar
* Put the Send Output to Editor Window menu item back in.
Note that I don't know if steps 1 and 5 were actually needed.  Also, I haven't tried to turn this on and off with the menu again, but at least I can build again without getting the .process editor tab. 

Perhaps the 'Process already running' message in step 3 is a clue to why it didn't work in the menu?  I don't remember seeing any message, though, when I tried to turn it off with the menu.

Navigation

[0] Message Index

[*] Previous page

Go to full version