Author Topic: SE Pro v27.0.0.6 "Not Responding"  (Read 166 times)


  • New Community Member
  • Posts: 1
  • Hero Points: 0
SE Pro v27.0.0.6 "Not Responding"
« on: December 19, 2022, 04:19:42 pm »
SE was in a state where it would immediately enter "Not Responding" lock-up on start-up. There was no getting past this point. It was also very difficult to kill in Task Manager. I suspect it is because in my last session I had files open from my WSL VM that were not getting resolved, but there was no recovery.

The solution to get back to normal came from a SE Support reply to a previous post:

Try this:

--Exit SlickEdit.

--In C:\Users\USERNAME\Documents\My SlickEdit Config\19.0.2\
   --RENAME your vslick.sta file to something like vslick.sta.bak
   --RENAME your vrestore.slk file to something like vrestore.slk.bak

--In the location of the SlickEdit Workspace/Project files (.vpw/.vpj) that you have opened in SlickEdit:
 --DELETE the .vpwhist file.
 --DELETE the .vtg file.

That should get you back into a stable state.

SlickEdit Support