« previous next »
Pages: 1 [2]   Go Down

Author Topic: Can't unload macro  (Read 15647 times)

chrisant

  • Senior Community Member
  • Posts: 1410
  • Hero Points: 131
Re: Can't unload macro
« Reply #15 on: February 23, 2009, 08:54:11 PM »
I keep my entire SE installation under source control, so I was able to sync backwards to an earlier revision of the state file, and rebuild changes that occurred since that revision.  Not the most pleasant resolution, perhaps, but it worked.
Report to moderator   Logged
Pages: 1 [2]   Go Up
« previous next »